WA Tach,Vac, Speedwarning cluster

[Livrat]

Originally was just a speedwarning dash, the tach hole was cleanly cut in the rear tin, Inner is a factory tach,vac tin, Tins have been media blasted and painted.
All factory OEM nice gauges with the needles repainted, speedo does have some minor blemishes on the black face (should be visible in the pic).

OEM circuit board dated 1972. New reproduction lense and a fairly new bezel that does have some of the black paint rubbed off in a couple of places (also visible in pics..

Sorry no buzzer, buzzer harness OR the adjuster cable (I robbed it for another cluster).

$475 shipped in the Lower 48 (PRICE REDUCED)

[Livrat]

More pictures

[tr69c10]

would you happen to have an extra speedwarning speedo laying around

[Livrat]

Sorry, No extra speedwarning parts at all.

[Livrat]

Price reduced to $475.00 shipped

[PT'S 70 CST]

I am going to get inline pending a close up pic of the speedo gauge face. I am concerned about the rust.


Thanks PT

[Livrat]

PT,
Post #2 picture #3 shows a fairly good closeup.. if you would like more let me know.
Thanks

[PT'S 70 CST]

If you do not mind give me one with the cluster in an upright position. Kind of a straight on shot of the face. Also does the warning needle turn freely and has the tach been tested.
Sorry to be picky but it is a lot of coin lay down if these things do not work.

Thanks PT

[Livrat]

I understand your concern,
Here is a few more pictures, yes the speedwarning needle move freely, and the tach works..Tthe speedometer had been in my 68 4X4 for the last 13 years, I swapped it with a real nice one, this speedo was in my house when it burned down in 1997 and has the blemishes on the face from the acidic smoke, it is also smoke blackened on the backside (should be visible in the pics)
The needle bounced some between 20-40 mph. If I was brave enough to try and remove the needles I would swap the speedo face with another one.

[PT'S 70 CST]

Thanks for the pics and let me think about it. As far as swapping the speedo face. I personally do not think it can be done because the white needle is press fit in. I have heard someone on here talk about swapping the face and I do not know if they actually did the swap or was just talking about it.

PT