Ram assist power steering hose rebuild?

[chewychevy67]

I am restoring my 67's ram steering assist. i have it all done and now i get to the hoses. i have new omega hoses. they will work but don't fit into the original locations where the brackets hold them in place. I have been told by a local hose fabricator that the originals are not rebuildable. I would like to know if anyone out has had theirs rebuilt or knows of a place that can do this for me.picture below but shows the hoses im talking about. mostly just need the ram to cylender hoses restored. Rod.

[GMCPaul]

Dad gets his at
Chicago Corvette Supply
7322 S. Archer Rd
Justice, Illinois
60458
708.458.2500 (Order)
708.458.6577 (Tech)
800.872.2446 (Order)
He purchase for a 63-67 Corvette as the lines and slave cylinders are the same the control valve for the Corvette used a different GM part # but they are a direct swap and offer improved handling, I don't have the part # for the hoses just call them and ask, heres part #'s for control valves
CCS P/N B6628 (Remanufactured)
CCS P/N B6629 (New)
GM P/N 5685459 (Remanufactured)
Heres the part# for the hydraulic slave cylinders
CCS P/N B6624 (Reman)
CCS P/N B6619 (New)
They also offer rebuild kits, ball studs, etc....
GMCPaul Jr

[chewychevy67]

those look so close but not quite bent how i would like them. they acually look like what i am using right now. anyone had originals restored?

[kcfirstbuild]

Might want to rebuild your control valve while your at it. It was simple like he said above corvett had the same set up.

[kcfirstbuild]

http://www.ecklerscorvette.com/steer...ing-hoses.html

[chewychevy67]

the pump and valve are new restored and the ram was rebuit all professionally. i just would like to have the hoses routed correctly between the valve and ram and they dont make them aftermarket . i even have new correct hoses from the pump to the valve. just need the 2 between the ram and the valve as shown in the pic.

[chewychevy67]

the pics i posted were before i had the parts restored. the corvette hoses have different bends in the metal lines than the truck. the corvettee hoses i believe will work but they wont line up with the bracket that holds the line steady and clear of the A arm and without that it will rub on the A arm. sorry for the confusion.

[chewychevy67]

up

[Classic Heartbeat]

I have mine rebuilt here localy by a company called Industrial Hydrolics. They did a pair on a 68 GMC that I had. WES

[chewychevy67]

here are current pictures and this is why i want my originals rehosed. you can see on the omega hoses the hoses will not line up with the mounting bracket. they just hang out there. and one has a shorter rubber hose than the other. last pic is of my originals. would have the ends replated before rehosing for show too.