![]() |
![]() |
#1 |
Registered User
Join Date: Aug 2009
Location: Red Wing Mn
Posts: 526
|
2'drop coil question.
Will I have any problems putting in my new front coil springs, they are 2" drop springs. I Don't have any weight , its just the frame. I Figure since they are 2" shorter they should go in with out any problems. I have the control arms on and ready to go for this weekend.
Thanks |
![]() |
![]() |
![]() |
#2 |
Junior Member
Join Date: Dec 2006
Location: Southeast Missouri
Posts: 2,436
|
Re: 2'drop coil question.
We did when we put coil springs in the front of my truck. We ended up putting 2 concrete blocks and two people on the frame to hold it down.
Later I read a post where you can run a chain under the floor jack and up and over the upper control arm and when you jack it up the chain will pull things in place. I have never tried this method yet so I am not sure about how it all works.
__________________
'67 Chevy C-20 short stepper - build complete, 454/SM-465. '75 C-30 Single Cab DRW-350 small block/NP-435. '77 GMC-6500 Dump Truck, 427 Tall Deck. '92 GMC K-3500 Duallie, 454/4L80E. |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Aug 2009
Location: Red Wing Mn
Posts: 526
|
Re: 2'drop coil question.
Is engine weight alone enough to jack up the lower control arm to install the spindle ?
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Aug 2009
Location: Red Wing Mn
Posts: 526
|
Re: 2'drop coil question.
bump ?
|
![]() |
![]() |
![]() |
#5 |
Quit if it's not FUN!!!
Join Date: Jul 2010
Location: Indian Trail, N.C,
Posts: 864
|
Re: 2'drop coil question.
![]() ![]() http://67-72chevytrucks.com/vboard/s...ad.php?t=18305 Read this thread. Bolt the a-arm crosshafts in place, without springs. READ AND LEARN! Good luck. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|