|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-21-2011, 11:37 AM
|
#1 |
|
Quit if it's not FUN!!!
Join Date: Jul 2010
Location: Indian Trail, N.C,
Posts: 864
|
Pitman arm question > >
  One for the guru's on the site. Are all P/S pitman arm's the same? Friend suggested my 70 C-10 may have a 1-ton P/S box znd I want to replace the arm. (and drag link). Thanks to the help and advice on this board, I'm going to Shades of The Past in Pigeon Forge and want to clean-up the steering, and stuff on some fresh rubber. Thanks Again ! ! ! |
|
|
|
08-22-2011, 06:44 PM
|
#2 |
|
Quit if it's not FUN!!!
Join Date: Jul 2010
Location: Indian Trail, N.C,
Posts: 864
|
Re: Pitman arm question > >
ttt
ANYBODY ? |
|
|
|
|
08-22-2011, 08:05 PM
|
#3 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Pitman arm question > >
1/2 ton and 3/4 ton box and arm are the same. I am not sure on the 1 ton box. Here is a picture of 2wd box and arm.
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
08-22-2011, 11:06 PM
|
#4 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: Pitman arm question > >
c/30 is the same as c/10 & C/20
|
|
|
|
|
08-23-2011, 06:48 AM
|
#5 |
|
Quit if it's not FUN!!!
Join Date: Jul 2010
Location: Indian Trail, N.C,
Posts: 864
|
Re: Pitman arm question > >
Thanks guys. It appears some stuff (rad.) was upsized. I will call my front end guy and tell him to go ahead and order parts. Friday we get new parts, fresh alignment, and all new rubber....
WHOO! Had side glass tinted(18%) and rear(5%) yesterday. really changes the whole feel of the truck Last edited by TobyArnot; 08-23-2011 at 07:03 AM. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
