|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-08-2011, 05:19 PM
|
#1 |
|
Registered User
 
Join Date: Feb 2008
Location: Harlingen, TX
Posts: 1,096
|
WTB: Spindle for Dana 44, 3/4ton 4x4/open knuckle
As the title says... i am helping a brother/truck owner find a drivers side, spindle for a Dana 44, open knuckle. I'm not an axle expert, so any help would be greatly appreciated.
shipping would be to 78550, money order is probably the best way for him to pay for it. Let me know what you have. thanks. Mondo |
|
|
|
09-08-2011, 07:30 PM
|
#2 |
|
Account Suspended
Join Date: Sep 2010
Location: centre al
Posts: 2,471
|
Re: WTB: Spindle for Dana 44, 3/4ton 4x4/open knuckle
i got one with the big bearings ?
|
|
|
|
|
09-08-2011, 09:26 PM
|
#3 |
|
Registered User
Join Date: Feb 2008
Location: Harlingen, TX
Posts: 1,096
|
Re: WTB: Spindle for Dana 44, 3/4ton 4x4/open knuckle
i know these pics probably wont help much, but i can't get any pics until tomorrow...
|
|
|
|
|
09-09-2011, 09:33 AM
|
#4 |
|
Special Order
  
Join Date: Nov 2004
Location: Mt Airy, MD
Posts: 85,851
|
Re: WTB: Spindle for Dana 44, 3/4ton 4x4/open knuckle
So this is for a '70? I'm not sure if that spindle is the same as for discs used 71-1st design '72. I know it's necessary to give the axle number (front of long tube) with the '72s. Maybe someone else will know for sure if the first disc spindle is the same. My guess is yes.
__________________
"BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed" GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project) GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling) Tim "Don't call me a redneck. I'm a rough cut country gentleman" R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~ |
|
|
|
|
09-25-2011, 09:18 PM
|
#5 |
|
Registered User
Join Date: Sep 2011
Location: colorado springs colorado
Posts: 49
|
Re: WTB: Spindle for Dana 44, 3/4ton 4x4/open knuckle
you need the hub not the spindle the hub holds the larger/outer part of the bearing the spindle is held on by 5 or 6 3/8th inch bolts its drum only or disk only for the hub i can get one here in co for 15.00+ ship if need be
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
