Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
10-18-2011, 09:50 PM | #1 |
True Addiction
Join Date: Nov 2005
Location: FTL
Posts: 415
|
Re: Dynatech MuscleMaxx Headers
Thanks, thats would put me flush with the bottom of my frame rails if measured from the top of the exhaust ports.
Did I read you were interested in selling them?
__________________
RCC |
10-19-2011, 01:30 PM | #2 |
Registered User
Join Date: Dec 2008
Location: port charlotte,florida
Posts: 384
|
Re: Dynatech MuscleMaxx Headers
big shoe, if you have a raised crossmember or [dropmember] they will hang 1.5" below the frame.The only way I can see around that is to open the tunnel up to decrease the angle.My output shaft angle is at 3 deg. down & the trans is pretty tight.The headers are first rate anyhow.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|