|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-17-2011, 09:55 PM
|
#1 |
|
Registered User
Join Date: Jun 2011
Location: Rio Rancho NM
Posts: 503
|
un arching leaf springs.
I have a 94 chevy that sags about 3/4" on the passenger side and I would like to get it fixed. I also would like to lower the rear of the truck 2" more. I went to the local suspension shop today to see what they could do about the lean from side to side and they said measure the difference and bring in one of the springs to arch or unarch to make the truck sit even from side to side. After that is complete I was going to buy leafspring hangers (front) to get the other 2 inches that I need. Since they are able to un arch springs do you think they could just un arch them to get 2" on one side and 2 3/4" on the other side? That would eliminate having to buy hangers and installing them which I heard was PITA. What would that do to my ride quality? Can they unarch springs that much? Any info on this would be appreciated.
|
|
|
|
11-18-2011, 07:11 AM
|
#2 |
|
Registered User
Join Date: Jan 2009
Location: Louisville,Ky
Posts: 5,811
|
Re: un arching leaf springs.
If it was me i would buy new springs and a drop kit,I mean i know a spring shop can re arch them but never used a set to know about the ride quality.
|
|
|
|
|
11-18-2011, 11:15 AM
|
#3 | |
|
Registered User
Join Date: Jun 2011
Location: Rio Rancho NM
Posts: 503
|
Re: un arching leaf springs.
Quote:
|
|
|
|
|
|
11-18-2011, 02:13 PM
|
#4 | |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,064
|
Re: un arching leaf springs.
Quote:
My thoughts would be 'why is there a difference now?'. If the springs are re-arched (de-arched in this case), how do you know the difference in height won't re-occur (maybe even be worse)? It would suck to spend the money only to have the issue not be corrected.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
|
11-22-2011, 11:44 AM
|
#5 |
|
Registered User
Join Date: Nov 2009
Location: Sonora California
Posts: 860
|
Re: un arching leaf springs.
What I did for mine was to gather up a few (three) sets of springs and take them appart. I layed out all the pieces and matched up a set with even arches. You will find several are sagged when appart. I doubled up two #3 springs. I have a stiff ride but I'll be able to carry some weight.
Total cost under 40 with extra spring pieces for yard art 
Last edited by 1LowToy; 11-22-2011 at 11:54 AM. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
