|
|
|
03-04-2012, 09:52 PM
|
#1 | |
|
Senior Member
 
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,856
|
Re: PO has me PO'd
Quote:
I really feel like this year is the one where i get to drive it Semper fi
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
|
|
03-04-2012, 10:04 PM
|
#2 |
|
Senior Member
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,856
|
Re: PO has me PO'd
Bearings in, weird on the wedge, never saw a bearing race installed like that...service manual says to run the nut down until all the space is taken up, then give it a 1/16 - 1/8 turn more. Make sure the streering shaft is straight, when you tighten the retaining nut
Finally, the tilt works....last part of the puzzle was to install the spring to control the return, just a phillips screw driver and alot of pressure  
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim Last edited by jaros44sr; 03-05-2012 at 02:55 PM. |
|
|
|
|
03-06-2012, 11:29 PM
|
#3 |
|
Senior Member
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,856
|
Re: PO has me PO'd
Got the wires fed thru the chase, canceling cam installed as well as the adapter for the wheel...getting close to getting outta this mess. Strip and paint cover, probably black
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
|
|
03-09-2012, 06:45 PM
|
#4 |
|
Senior Member
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,856
|
Re: PO has me PO'd
Yep, you guessed it....turnsignal/cruise stalk, as well as turnsignal switch screws have to be removed to get the cover plate on, if you have the red hazard button...
Thats it, next time ill get the three pieces powder coated grey 
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
