![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jan 2010
Location: az
Posts: 169
|
6.0 LQ4 Drive by cable
Im getting ready to install the 6.0 engine into the 71 and just realized its a drive by cable. To be honest, I never payed much attention as I was planning to do a carbed set-up at the time. But after month's of reading, I realized I'd be a fool to not run the fuel injection. Unfortuanetly I wasn't aware that I needed the gas pedal and tac module when I got the engine.
Has anyone just used the stock pedal assembly? I realize the drive by wire is an easier set-up for cruise control, but cruise is not that important at this time, and I dont want to change intakes. Any help appreciated |
![]() |
![]() |
![]() |
#2 |
c10 Chop Artist
Join Date: Feb 2007
Location: az
Posts: 481
|
Re: 6.0 LQ4 Drive by cable
You can use a cable actuated throttle but you have to change the t-body. If you keep the drive by wire you have to get the electronic pedal. There is also a short dedicated wire harness that goes from the pedal to the electronic t-body.
__________________
65 c10 build http://67-72chevytrucks.com/vboard/s...d.php?t=467433 68 c10 on 22's (sold it) http://67-72chevytrucks.com/vboard/s...d.php?t=303594 |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Oct 2008
Location: Marianna Arkansas
Posts: 7,270
|
Re: 6.0 LQ4 Drive by cable
If you keep the drive by wire, you have cruise control built into the tac module and all that would be missing is the cruise wiring. That would be a plus
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|