|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-14-2013, 09:25 AM
|
#1 |
|
Registered User
Join Date: Dec 2011
Location: Perth Western Australia
Posts: 146
|
1958 Chevy Wheel Fitment
Hey,
I have found a set of Boyds on a local site here, they are 6 lug, Front: 17" x 8" - Offset: 20 , Rear: 17" x 9.5" - Offset: 24 with a PCD: 139.7. Does anyone know if these will fit? Thanks Shane
__________________
Australian GM/Holden Dealer 1937 Chev Rod - LS1/4L60E 1949 Chevy 4400 Dually - 235ci/4L60E 1958 Chevy Apache Fleetside SBC/T400 |
|
|
|
01-15-2013, 08:46 AM
|
#2 |
|
Registered User
Join Date: Dec 2011
Location: Perth Western Australia
Posts: 146
|
Re: 1958 Chevy Wheel Fitment
Anyone Please ???
__________________
Australian GM/Holden Dealer 1937 Chev Rod - LS1/4L60E 1949 Chevy 4400 Dually - 235ci/4L60E 1958 Chevy Apache Fleetside SBC/T400 |
|
|
|
|
01-15-2013, 02:04 PM
|
#3 |
|
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: 1958 Chevy Wheel Fitment
Offset is not making sense to this Yank, is it in centimeters? Maybe a Boyd's model number and pic would help?? I'm running stock steel wheels so not experience with aftermarket stuff on the trucks.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
|
|
|
|
01-16-2013, 11:10 AM
|
#4 |
|
Registered User
Join Date: Dec 2011
Location: Perth Western Australia
Posts: 146
|
Re: 1958 Chevy Wheel Fitment
OrrieG,
The PCD is 55 inch. The wheels are Classic 17" the link is http://www.gumtree.com.au/s-ad/quinn...oys/1010520593 if that helps? Thanks Again Shane
__________________
Australian GM/Holden Dealer 1937 Chev Rod - LS1/4L60E 1949 Chevy 4400 Dually - 235ci/4L60E 1958 Chevy Apache Fleetside SBC/T400 |
|
|
|
|
01-17-2013, 12:33 AM
|
#5 |
|
Senior Member
 
Join Date: Aug 2010
Location: Shasta Lake, CA.
Posts: 1,624
|
Re: 1958 Chevy Wheel Fitment
The hole that has to slip over the hub most likely is too small.
Best check the hub dimensions and the wheel for compatibility. The late model wheels are hub centric i.e. they center on the hub not the lugs. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
