Tie rods won’t fit new CPP spindles???

[biohazardbill]

Originally Posted by Lost81c10

Returned the spindles and got a replacement set same brand and part #. This time I had them open the box and used one of my new tie rods to test the hole. Big difference in size. Don't know if they gave me the wrong ones or they were deffective. They are now installed with 1.5 western chassis springs. Could not take pics as it was dark and started to rain just as I returned from the test drive. Feels good on the turns. I still have the heavy lean on the driver side. I though it would go away but guess not.
I was thinking about letting the springs settle and see how it is in a couple of weeks. If no difference then I will cut a little off the passenger side spring. Do you guys think that will work in leveling the sides?
Posted via Mobile Device

Not to bring up old thread but I had same issue today. Did you take the spindles back to Summit? Or did you have to send back to CPP?

[Lost81c10]

Originally Posted by biohazardbill

Not to bring up old thread but I had same issue today. Did you take the spindles back to Summit? Or did you have to send back to CPP?

I took them back to summit. I called cpp and they said it was a summit issue.
Posted via Mobile Device

[INSIDIOUS '86]

Originally Posted by Lost81c10

I took them back to summit. I called cpp and they said it was a summit issue.
Posted via Mobile Device

Yes cause summit drills them smaller...smh
Posted via Mobile Device