1966 SBFS project low and go

[wutnxt]

Spent some time under the truck yesturday and found a few more challenges......nothing that can't be fixed or altered to work. This isn't the first time I have bought a poject truck and finished it off....I think most of us have been down this road and know what comes wih it. I wasn't thinking LSA when I bought it but I was thinking maybe LS . Someone else had a differnt vision when they had it and so on....and thats how it rolls so to speak.


-The floor patches need a little TLC from the bottom side and the rockers inners aren't welded to the rocker outers
-The new wire harness needs to be pulled out... wrapped and attached to the frame
-The rear end angle is way out and is going to need to reduced by about 6 degrees
-Brake lines all need to be redone and rerouted...

Good news is all the big stuff looks like it has game.....just some clean up here and there. But hey just a small shout out to the the guy that welded a " J " beside the " PB " that is in the center of the front cross member (porter built ). Once it was up on the hoist and we stood there looking at it....my buddy is convinced it stands for "peanut butter and jam " I don't think there was anyone who didn't laugh.....it didn't help it was lunch time and we were hungry.....