|
03-20-2002, 05:20 PM
|
#1 |
|
Registered User
Join Date: May 2001
Location: Arizona
Posts: 758
|
Frame Supports
I know this has probably been talked about thousands of times already, but I was wondering if some one could tell me the best way to replace the floor supports? Should I take the cab all the way off? Thanks for any help you can give.
------------------ http://www.geocities.com/a68rod
__________________
Build Thread |
|
|
|
03-20-2002, 05:37 PM
|
#2 |
|
Account Suspended
Join Date: May 2000
Location: IL
Posts: 0
|
that would be the easiest scenario, but not everyone wants or does pull cab off to replace them, putting cab on its side on rollers or dollies of some kind would be the ultimate set up for cleaning and painting and repairing cab floor stuff
good luck ------------------ -71/C-10(thx teeitup and crews!)350 4+4/CH465(thx 71Chev, GMCPaul, and CPNE)longfleet bed(thnx meathead95)!still building it- -'84 Z28(Z28) 1G1AP87GXEL100000 with H.O. 305/4bbl/190net/hp(L69) 3.73 rear(GT4/YC4) 700R4(MD8-MXO) & other goodies  -79 G20 pass van, 350/th350/10bolt, paint is overrated Randy- Lincoln, IL randy@ccaonline.com © RSS Enterprises 2000 |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
