INSTALL: Tennman's Sidemarker Fuel Fill on a Stepside - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jorgensensc · 11-17-2003, 09:45 PM

Thanks for all of the support guys!!!
I hope no one thinks this is my idea!!! I just modified Tennman's install for a stepside.
Bigvinnie,
It is only a slight uphill slant, and the force of the gas going through the nozzle pushes it through just fine. I have yet to have it back up on me.
Thanks again for the encouragement!!!
Shawn
P.S. I don't know if Josh decides about what goes to the FAQ section, but I think both the blazer tank install and this install would be good candidates.

11-17-2003, 09:45 PM	#20
jorgensensc Registered User Join Date: Jul 2003 Location: Cypress, Tx Posts: 4,005	Thanks for all of the support guys!!! I hope no one thinks this is my idea!!! I just modified Tennman's install for a stepside. Bigvinnie, It is only a slight uphill slant, and the force of the gas going through the nozzle pushes it through just fine. I have yet to have it back up on me. Thanks again for the encouragement!!! Shawn P.S. I don't know if Josh decides about what goes to the FAQ section, but I think both the blazer tank install and this install would be good candidates. __________________ 1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.