![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
![]() Join Date: Oct 2012
Location: Newhall CA
Posts: 1,195
|
6 cylinder to 350 /700r4 will drive shaft fit?
my truck had a six with 3 speed manual trans, moving the 350 forward to the factory spot, with 700r4 trans...will my driveshaft fit?
I read somewhere it will work....
__________________
69 SWB 780hp Hellcat powered, manual 6 speed, currie 9 |
![]() |
![]() |
![]() |
#2 |
Watch out for your cornhole !
![]() Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: 6 cylinder to 350 /700r4 will drive shaft fit?
Yes, as long as you use the small block engine stands in the front holes.
Posted via Mobile Device |
![]() |
![]() |
![]() |
#3 |
Registered User
![]() Join Date: Oct 2012
Location: Newhall CA
Posts: 1,195
|
Re: 6 cylinder to 350 /700r4 will drive shaft fit?
thats what im going to use....
thank you
__________________
69 SWB 780hp Hellcat powered, manual 6 speed, currie 9 |
![]() |
![]() |
![]() |
#4 |
Registered User
![]() Join Date: Oct 2012
Location: Newhall CA
Posts: 1,195
|
Re: 6 cylinder to 350 /700r4 will drive shaft fit?
well my driveshaft did fit but, was 1.25 inches to short, not sure why.... oh well whats another 200.00.....
__________________
69 SWB 780hp Hellcat powered, manual 6 speed, currie 9 |
![]() |
![]() |
![]() |
#5 |
Watch out for your cornhole !
![]() Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: 6 cylinder to 350 /700r4 will drive shaft fit?
You used a small block engine, 700r4, and the front set of holes with small block stands ? The stands are bolted down with the factory holes and all three bolts each ?
I've done this exact swap an the driveshaft worked as is. Posted via Mobile Device |
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: Jun 2010
Location: Fayetteville, GA
Posts: 214
|
Re: 6 cylinder to 350 /700r4 will drive shaft fit?
Aren't there a couple of different factory three-speed transmissions? I know mine has a non-syncronized 1st gear and I thought I read where it was shorter than the other available three-speeds? (I don't have the numbers handy at the moment......hopefully someone else might?)
__________________
1968 SWB Stepside "Bella coming home" "Bella's Build Thread" A master in the art of living draws no sharp distinction between his work and his play. He simply pursues his vision of excellence through whatever he is doing, and leaves others to determine whether he is working or playing. To himself, he always appears to be doing both. L. P. Jack |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|