|
11-11-2003, 09:48 AM
|
#1 |
|
Red Headed Step Child
Join Date: Oct 2003
Location: Atlanta, GA
Posts: 1,216
|
Turn signal lever
I got my new turn signal lever yesterday and went to put it on last night but was missing one important part. The screw that holds it in place
 . I went through everything i had and nothing fit. Does anyone have a manual or anything that would say what size screw this is? I don't want to have to end up buying the whole lot at Lowe's just to get 1 tiny screw. It's for a 1970 Chevy C-10. I know it's a dumb question but thanks in advance
__________________
"Dinner, the perfect break between work and drunk" -Homer Simpson |
|
|
|
11-11-2003, 05:18 PM
|
#2 |
|
Red Headed Step Child
Join Date: Oct 2003
Location: Atlanta, GA
Posts: 1,216
|
bump
__________________
"Dinner, the perfect break between work and drunk" -Homer Simpson |
|
|
|
|
11-11-2003, 05:40 PM
|
#3 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Hmm, it is super short and pretty dang small.
I would post a WTB thread on the parts board...I'll bet some one will just give it to you for shipping. I would but I don't have anything here. |
|
|
|
|
11-11-2003, 05:55 PM
|
#4 |
|
Account Suspended
Join Date: Jul 2003
Posts: 1,284
|
P.M. me your address and I will send you one (dont worry about shipping)
Shawn |
|
|
|
|
11-23-2003, 12:28 AM
|
#5 |
|
Cause the Chicks DIG IT!!
Join Date: Nov 2003
Location: Beaufort SC
Posts: 509
|
he he he try one out of your glovebox screws. There just a little tall so you might have to shave em down a bit!!
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
