whats the thread size for the steering shaft? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

TX58 · 06-03-2013, 02:00 AM

I'm reading 1/2"-20 from other sources
Not sure what classic sent me. I'm pissed because now I have to go out and buy a new nut and the tool to cut new threads.
Thanks for your help, I'll try that other size for the glovebox door
Posted via Mobile Device

OrrieG · 06-04-2013, 12:21 AM

You might be right, I assumed that since the spline was the same on my 82 column the nut was the same size. My original column is long gone. I did a quick search and the 1/2 x 20 came up for some 50's gm applications.

06-03-2013, 02:00 AM	#1
TX58 Registered User Join Date: Dec 2011 Location: Humble,TX Posts: 287	Re: whats the thread size for the steering shaft? I'm reading 1/2"-20 from other sources Not sure what classic sent me. I'm pissed because now I have to go out and buy a new nut and the tool to cut new threads. Thanks for your help, I'll try that other size for the glovebox door Posted via Mobile Device

06-04-2013, 12:21 AM	#2
OrrieG Registered User Join Date: Jun 2006 Location: Idaho Posts: 8,800	Re: whats the thread size for the steering shaft? You might be right, I assumed that since the spline was the same on my 82 column the nut was the same size. My original column is long gone. I did a quick search and the 1/2 x 20 came up for some 50's gm applications. __________________ 1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.