|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-14-2013, 01:17 AM
|
#9 |
|
Registered User
Join Date: Aug 2009
Location: Bowser
Posts: 13,974
|
Re: Bell tech lowering questions.
I think you'll get a suprise when you run out of thread while torqueing them to 140 lb/ft.
You'll be out of thread just tightening them by hand. Easier to cut another inch or two on each side. What are you doing about your pinion angle adjustment? |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode