Cab corners and rockers - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**steelhorse** · 11-01-2013, 10:36 AM

I need to weld in some new cab corners and probably some new rockers also in my 67. So do I need to remount the cab before I do this or can I do it with the cab on a dolly? The floor pans and everything else is in good shape. Just want to make sure the gaps come out right.

*Fitz* · 11-01-2013, 12:28 PM

Quote:

Originally Posted by steelhorse

I need to weld in some new cab corners and probably some new rockers also in my 67. So do I need to remount the cab before I do this or can I do it with the cab on a dolly? The floor pans and everything else is in good shape. Just want to make sure the gaps come out right.

Hard to say without photo's.

11-01-2013, 10:36 AM	#1
steelhorse Senior Member Join Date: Apr 2008 Location: Franklinton NC Posts: 1,309	Cab corners and rockers I need to weld in some new cab corners and probably some new rockers also in my 67. So do I need to remount the cab before I do this or can I do it with the cab on a dolly? The floor pans and everything else is in good shape. Just want to make sure the gaps come out right.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.