![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Dec 2012
Location: Virginia
Posts: 233
|
Re: Stripped Threads in Dana 60 Rear Axle Wheel Hub
keep in mind that those 8 bolts on the the hub are the only hardware that is holding the axle in place.
Thats why there are 8 bolts. Thats a lota bolts. I am glad you brought that up because that is next to the last on my to do list. On your truck was there a gasket between the axle flange and the hub? |
![]() |
![]() |
![]() |
#2 |
1972 C/20
Join Date: May 2005
Location: Santa Rosa, Ca
Posts: 273
|
Re: Stripped Threads in Dana 60 Rear Axle Wheel Hub
resurrecting another old thread because this info is HARD to find. :-)
Regarding the aluminum gaskets, Ive heard of folks putting a thin layer of gasket sealer and some not. Any pros and cons to this? |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|