Need some help on set of bell tech spindles

[71 super]

The 67 I just picked up came with a complete front end rebuild kit- new upper lower ball joints, tie rods etc. also came with a set of bell tech spindles. Now to the problem, I bought inner and outer bearings and set of 5 lug rotors- re drilling them to 6 lug at work- bought a5 and a3 inner and outer bearings, the a5 s work without issue, the a3 are too small on the id. Is there a special bearing for these spindles? Also where can I get nuts and washers for spindles to hold bearings on?

[mgchevyparts]

Often times there may be a slight burr on the spindle tip, usually where the groove is flycut for the tanged washer. Hit this area with a flat file and generally inspect the entire spindle end for any type of burr. unless you're saying the i.d. is way off.

[leddzepp]

Iirc bell tech spindles are a 3" drop as opposed to 2.5" like most others. If you are going to run 15" wheels you may have clearance issues. I know this isn't your question but it is something that might come up.

[71 super]

Got the bearing issue fixed, going to run 20" wheels so should be good. Thank you for the replies.