Lets talk about laying rockers

[Slammed96]

Ok all, I have a 64 C10 Short bed fleet side I would like to put in the weeds. Ideally my plan is to swap in a 73-87 front crossmember, rear dropmember, and do a 2.5 or 3in. Z on the frame. My question is will this be enough to lay the rockers when the truck is aired out? I'm aware that I will need to address steering and trans crossmember issues, but is there anything else that I will encounter? Ive been reading as much as I can, but more knowledge means more questions as my ideas grow.

[tinydb84]

You can drop the body mounts an inch to get the body down where you want it. You will have to remount the bed as well.

[Slammed96]

Will that still clear my floor or will I need to channel it if I go that route?

[tinydb84]

You will clear the floor. No sectioning needed.

[Slammed96]

If I go with that how much will need to be adjusted to further clear? Like steering,trans tunnel, etc.

[tinydb84]

Steering, tranny tunnel, possibly a bit of your fire wall depending on engine position. This build shows a lot: http://67-72chevytrucks.com/vboard/s...d.php?t=269019

[Slammed96]

Sweet thanks man!