Marquez side marker lights

[Fldawg]

Ok guys just got my marquez side marker light lens and was wondering how everybody mounted the light that go behind them or did you just take the bulb out and tie up the harness, since the lens have all reflective lens in it this might not be a big deal. but i would like to mount the lights.any help or pics appreciated.

[Fldawg]

anybody!!!

[screaminchevypickup]

I always cut the fronts off the factory lights and sandwich it between the billet part and the body!!

[Fldawg]

Originally Posted by screaminchevypickup

I always cut the fronts off the factory lights and sandwich it between the billet part and the body!!

i was thinking about that, but i wanted the new lens to sit flush and not stick out like the factory ones

[rob32472]

As nice as they are and as expensive as they are they should come with lights! Just sayin.....

[Fldawg]

Originally Posted by rob32472

As nice as they are and as expensive as they are they should come with lights! Just sayin.....

That's what i thought, but could you imagine how much they would be.there taillights with leds in them are $829 Crazy. i just got tired of having to glue my trim back on those repop marker lights and nos markers are just as expensive so why not go with the billet ones

[screaminchevypickup]

Originally Posted by Fldawg

i was thinking about that, but i wanted the new lens to sit flush and not stick out like the factory ones

Your only talking a 1/16th of a inch if you cut down the light right!!

[Fldawg]

Originally Posted by screaminchevypickup

Your only talking a 1/16th of a inch if you cut down the light right!!

those look good like that, i'll cut one of my old lights and try it that way first, if i like it i'll use it, Thanks

[jaros44sr]

Heres mine.....separated the bulb holder from the reflective lense, and used a router table to remove the unwanted plastic


20140411_103031 by james_jaros, on Flickr

[Fldawg]

Originally Posted by jaros44sr

Heres mine.....separated the bulb holder from the reflective lense, and used a router table to remove the unwanted plastic


20140411_103031 by james_jaros, on Flickr

I have a show this weekend and put them on with out lights, i will do that later, thanks for the pic and the tip

[Fldawg]

Originally Posted by jaros44sr

Heres mine.....separated the bulb holder from the reflective lense, and used a router table to remove the unwanted plastic


20140411_103031 by james_jaros, on Flickr

did you use the gaskets behind the lens and how much plastic did you take off

[BossHogg69]

I have the same Marquez lights, but I've been looking for a way to mount an LED light board behind them.

[Fldawg]

Originally Posted by BossHogg69

I have the same Marquez lights, but I've been looking for a way to mount an LED light board behind them.

i think marquez sells the taillights with leds in them but are very expensive
to the tune of $849, post up a pic if you figure it out