|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-02-2004, 03:17 PM
|
#1 |
|
Registered User
Join Date: Sep 2003
Location: albuqueque
Posts: 105
|
stamped codes on front end???
i just picked up a new disc brake front end...is there any where on it i can find the gear ratios stamped or codes, or do i have to count the teeth...all i found was the 44 thanks - todd
|
|
|
|
01-02-2004, 04:34 PM
|
#2 |
|
Beer Power!!!!!!!!!!
Join Date: Nov 2003
Location: Nacogdoches, TX
Posts: 280
|
ear ratio for the rear end?
__________________
Rather be fishin' |
|
|
|
|
01-02-2004, 06:56 PM
|
#3 |
|
Registered User
Join Date: Dec 1999
Location: Old Mission, MI, USA
Posts: 2,507
|
The BOM number is stamped on the front side of the drivers side axle tube starting a couple of inches over from the center section. A Dana/Spicer dealer can tell you the original application and ratio from that number.
__________________
Tim |
|
|
|
|
01-03-2004, 02:19 AM
|
#4 |
|
Registered User
Join Date: Sep 2003
Location: albuqueque
Posts: 105
|
i found this site, thought it might help some of ya
http://www.melanchete.com/bob/dana_axle_ident.htm |
|
|
|
|
01-03-2004, 09:26 AM
|
#5 |
|
Registered User
Join Date: Dec 1999
Location: Old Mission, MI, USA
Posts: 2,507
|
You can also get that info at the Dana Corp. web site. The problem is tht they both only go back to 1979 or so. If you want to decode the older numbers, you have to find a Dana Spicer dealer that keeps their old books.
__________________
Tim |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
