need length - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Gary 70 Jimmy** · 01-11-2004, 03:40 PM

I took the floor out of my jimmy and now I have to put it back in does anyone know what the length is across the back where the tail gate goes so when I weld it it is in wright spot. thanks gary

JimKshortstep4x4 · 01-11-2004, 08:04 PM

Gary,

I am not sure what you are asking for but this is what I measured.

Distance beween mounting surfaces, (where the hinges mount to the sides), 68"

Distance between the two stake pockets, 65".

If these are not the measurements needed, just let me know and I will try to get what you need.

Jim

**Gary 70 Jimmy** · 01-11-2004, 10:43 PM

That is what I need thanks jim

01-11-2004, 03:40 PM	#1
Gary 70 Jimmy Senior Member Join Date: Jan 2002 Location: Burghill, Ohio 44404 Posts: 3,402	need length I took the floor out of my jimmy and now I have to put it back in does anyone know what the length is across the back where the tail gate goes so when I weld it it is in wright spot. thanks gary

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-11-2004, 08:04 PM	#2
JimKshortstep4x4 Senior Member Join Date: Jul 2001 Location: Muskegon,MI,USA Posts: 6,026	Gary, I am not sure what you are asking for but this is what I measured. Distance beween mounting surfaces, (where the hinges mount to the sides), 68" Distance between the two stake pockets, 65". If these are not the measurements needed, just let me know and I will try to get what you need. Jim

01-11-2004, 10:43 PM	#3
Gary 70 Jimmy Senior Member Join Date: Jan 2002 Location: Burghill, Ohio 44404 Posts: 3,402	That is what I need thanks jim



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.