|
07-26-2014, 11:52 AM
|
#1 |
|
Senior Member
 
Join Date: Feb 2012
Location: chillicothe, illinois
Posts: 690
|
3/4 to 1/2 conversion
I am taking out the eaton and putting in a 12 bolt for the rear. In the front can I just leave the upper and lower control arms and change ball joints to put on 1/2 ton disc spindles?? I do know that I will have to change the center link to a 71-72 and tie rods ends of the same year.
|
|
|
|
07-26-2014, 12:05 PM
|
#2 |
|
Registered User
Join Date: Jun 2010
Location: British Columbia
Posts: 192
|
Re: 3/4 to 1/2 conversion
The lower a arms won't work for u 1/2 ton ball joints don't fit in them. The uppers are OK though. Just put in the new 1/2 ton uppers and bolt in 1/2 ton lower arms. And then rest your correct on.
__________________
If you can't impress them with your inteligence, dazzle'm with your stupidity 1969 GMC lwb 2wheel drive can you say big stroker motor to come hehe |
|
|
|
|
07-26-2014, 12:09 PM
|
#3 |
|
Senior Member
Join Date: Feb 2012
Location: chillicothe, illinois
Posts: 690
|
Re: 3/4 to 1/2 conversion
cool thanks
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
