![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: May 2012
Location: Falls Church, Virginia
Posts: 65
|
Door hinge pin removal
Any advice on getting the pins out of the door hinges? PB Blaster, vise, and a hammer aren't getting it done. Don't have a torch. Thanks
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: May 2014
Location: Kewanee IL
Posts: 283
|
Re: Door hinge pin removal
3 of my 4 came apart as should 4th one I took to work (did it on my breaks) and milled it out. I then got a bigger pin and bushings for it
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jun 2004
Location: El Lago, TX
Posts: 1,668
|
Re: Door hinge pin removal
I don't have specific experience with 60-66 trucks, but on other years if you cut the pin right in the middle with a cut off wheel they come right out once they are broken into two pieces.
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Jun 2013
Location: Somewhere
Posts: 3,079
|
Re: Door hinge pin removal
Not sure on earlier years, but I think 67-72 are staked on the bottom. Grind off the rounded head rather than the staked end and drive out with a drift.
Soak them in ATF for a few days. Put them in your oven for an hour at the highest temp. You can get a propane torch for sweating copper at the home store for a few bucks. Heat the hinge, not the pin. Send it to me, I'll get it out. ![]() Just a few ideas. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|