|
09-03-2014, 06:20 PM
|
#1 |
|
JRods Garage
Join Date: Dec 2009
Location: East Highland, CA
Posts: 1,098
|
High Hump Cutout
Hey guys, I have a curiosity... I have ordered a high hump trans tunnel for my DM/LS swap C10, but the hump wont be in until next week. Im looking to get my engine installed this week and I want to cut out the section where it will sit. Is there a template or a stamp mark in the floorboard that might be a good reference?
I appreciate the help! 
|
|
|
|
09-03-2014, 07:34 PM
|
#2 |
|
Registered User
 
Join Date: Jun 2012
Location: Fitchburg,Mass
Posts: 737
|
Re: High Hump Cutout
I did this last weekend. do not have any good pics but these. hope it helps
__________________
62 Willys 4wd Pickup : 72 C-10 swb 504 stroker  09 Taco 3" lift 33" tires: 90 K-5 blazer (plow truck): RIP Ross Little brother
|
|
|
|
|
09-03-2014, 09:57 PM
|
#3 |
|
Registered User
Join Date: Jun 2011
Location: United States
Posts: 159
|
Re: High Hump Cutout
|
|
|
|
|
09-03-2014, 10:02 PM
|
#4 |
|
Registered User
Join Date: Jun 2013
Location: West Virginia
Posts: 6,427
|
Re: High Hump Cutout
DON'T DO IT.
Wait until you have the replacement piece. Cutting before then might result in a big headache if your calculations are off. I've learned the hard way to wait until I have all the pieces on hand before moving forward. You can wait a few more days...find something else to do. |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
