|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-27-2014, 02:14 PM
|
#26 |
|
Registered User
 Join Date: Oct 2012
Location: Newhall CA
Posts: 1,195
|
Re: Ripped the crossmember
any pictures of your front lower A ARMS???
__________________
69 SWB 780hp Hellcat powered, manual 6 speed, currie 9 |
|
|
|
10-27-2014, 03:18 PM
|
#27 |
|
Registered User
Join Date: Feb 2013
Location: Martinez California
Posts: 193
|
Re: Ripped the crossmember
No that I look at it they aren't 45*. Closer to 25*
__________________
HOTROD HOODLUM 
|
|
|
|
|
10-27-2014, 03:21 PM
|
#28 |
|
Registered User
Join Date: Feb 2013
Location: Martinez California
Posts: 193
|
Re: Ripped the crossmember
Not much room for a watts. Ill have to move some stuff around back there.
__________________
HOTROD HOODLUM
|
|
|
|
|
10-27-2014, 04:24 PM
|
#29 |
|
Registered User
Join Date: Oct 2012
Location: Burnet, Tx
Posts: 332
|
Re: Ripped the crossmember
There's plenty room, it would connect to the rear portion of your notch.
|
|
|
|
|
10-27-2014, 05:06 PM
|
#30 |
|
Registered User
Join Date: Feb 2013
Location: Martinez California
Posts: 193
|
Re: Ripped the crossmember
Yeah i could make it fit. I was talking about the center main pivot point of the watts. The universal weld on kits I've seen bridge over the differential cover. There is only a few inches between my cover and the cross member that that wire splitter is mounted to. Then my tanks are right behind that. I suppose I could get one of those that bolt up to the differential but I'd rather weld it to the axle. this is what im talking about
http://www.bcfab.com/Universal-Watts...it_p_1022.html http://www.alldayfab.com/Suspension-Components.html
__________________
HOTROD HOODLUM
|
|
|
|
|
10-27-2014, 06:01 PM
|
#31 |
|
Registered User
Join Date: Oct 2012
Location: Burnet, Tx
Posts: 332
|
Re: Ripped the crossmember
Or something like this
|
|
|
|
|
10-27-2014, 06:05 PM
|
#32 |
|
Registered User
Join Date: Feb 2013
Location: Martinez California
Posts: 193
|
Re: Ripped the crossmember
^^^ that thing is rad.
__________________
HOTROD HOODLUM
|
|
|
|
|
10-27-2014, 06:16 PM
|
#33 |
|
Registered User
Join Date: Oct 2012
Location: Burnet, Tx
Posts: 332
|
Re: Ripped the crossmember
My buddy John is a fabricating wiz, he does some pretty trick stuff. Check him out on Instagram, might get a few ideas. Chassisfabjohn
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
