help with steering wheel install - The 1947 - Present Chevrolet & GMC Truck Message Board Network

OrrieG · 12-09-2014, 07:44 PM

Did you get the part that mounts to the spline pulled all the way down? Nut looks flush with the end of the splined shaft, usually there is about 3/8-1/2" thread showing. That would explain the gap....

57chevyman · 12-09-2014, 08:15 PM

Quote:

Originally Posted by OrrieG

Did you get the part that mounts to the spline pulled all the way down? Nut looks flush with the end of the splined shaft, usually there is about 3/8-1/2" thread showing. That would explain the gap....

yeah my mistake.. that was just threaded on by hand in that pic. 1/4" gap closed up when i tightened that nut down

12-09-2014, 07:44 PM	#1
OrrieG Registered User Join Date: Jun 2006 Location: Idaho Posts: 8,800	Re: help with steering wheel install Did you get the part that mounts to the spline pulled all the way down? Nut looks flush with the end of the splined shaft, usually there is about 3/8-1/2" thread showing. That would explain the gap.... __________________ 1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.