|
01-09-2015, 06:10 PM
|
#1 |
|
Registered User
Join Date: Oct 2014
Location: Gulfport Ms.
Posts: 27
|
Transmission Swap
Will the three speed manual transmission from a 1981 c10 with a 292 6 cylinder fit my 1967 250 cylinder bell housing and clutch disc splines ?
__________________
We make too many wrong mistakes..................Yogi Berra |
|
|
|
01-09-2015, 11:50 PM
|
#2 |
|
Member #1049
Join Date: Jun 2000
Location: Troy Montana
Posts: 3,940
|
Re: Transmission Swap
if the 81 transmission has a 10 spline input shaft it will fit your clutch disc, but I do believe the 67 bell housing has a smaller hole for the throw out collar than the 81
|
|
|
|
|
01-10-2015, 06:44 PM
|
#3 |
|
Registered User
Join Date: Oct 2014
Location: Gulfport Ms.
Posts: 27
|
Re: Transmission Swap
Are you referring to the hole where the transmission input shaft enters the bell housing or where the throw out bearing fork enters ? Thanks for your reply.
__________________
We make too many wrong mistakes..................Yogi Berra |
|
|
|
|
01-11-2015, 12:00 PM
|
#4 |
|
Member #1049
Join Date: Jun 2000
Location: Troy Montana
Posts: 3,940
|
Re: Transmission Swap
I am referring to the hole were the trans enters the bell housing
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
