|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-26-2015, 10:01 PM
|
#1 |
|
Rusty Nuts
Join Date: Sep 2008
Location: Clever Missouri
Posts: 1,338
|
oil pump alignmen tool
I wasted about thirty minutes trying to line my oil pump for my distributor,then I made this. It is a pvc coupler put over my screwdriver tip, slides on every time with ease. It's not that big of a deal to do if the engine is on a stand but if it's in the truck it sucks to fight with.
__________________
(Clever Missouri) Southwest Larry Mr Chevrolet My Build, The Marathon Truck http://67-72chevytrucks.com/vboard/s...d.php?t=604414 |
|
|
|
01-27-2015, 07:53 AM
|
#2 |
|
Senior Member
 
Join Date: Jan 2011
Location: Hayes Va
Posts: 4,569
|
Re: oil pump alignmen tool
I set the distributor in the hole where I want it and just bump the engine. Drops right down. Bring it back around to where I want to set the timing to and line the rotor up with the mark on the distributor for the number one wire. Snug it up and done, ready to put the cap on and run it to set it with the light. Takes a couple of minutes at most.
Jimmy
__________________
60 to 66 Chevy and GMC window decals http://67-72chevytrucks.com/vboard/s...d.php?t=661131 Good friends, good food and a hotrod what else do you need? 1966 BBW long fleet Daily driver 1965 BBW short fleet Sold and going to a good home 1965 Suburban 2003 3500 Duramax 2005 Ultra Classic |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
