|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-03-2004, 03:27 PM
|
#1 |
|
Registered User
Join Date: Jan 2001
Location: OliveBranch, MS
Posts: 154
|
drive shaft replacement
Has anyone found a one-piece drive shaft that will fit a swb with a th350 transmission?
__________________
69 Chevy ProStreet, Low and wild. 78 Corvette rturnpaugh@compcams.com |
|
|
|
02-03-2004, 03:36 PM
|
#2 |
|
This, is my BOOMSTICK!
Join Date: Oct 2003
Location: Berlin, CT
Posts: 1,310
|
I don't know who has them but I know that the parts place that my uncle works for cuts drive shafts down to specification. I think that the place is called Truck Parts USA, I think.
__________________
Larry Got rid of my projects for now. 1980 Jeep CJ7 1998 Nissan Sentra (my car) 2001 Toyota Sienna (wife's, of course) |
|
|
|
|
02-03-2004, 04:22 PM
|
#3 |
|
Formerly yellow72custom
Join Date: May 2001
Location: Austin, TX
Posts: 7,531
|
A local driveshaft shop should be able to fab one up for you
__________________
'72 Chevy C10 Mild 350/TH350/3.07. Ochre/White. Old high school ride. '70 GMC C2500 '62 327 4bbl/SM465/4.56-geared Dana 60. White/White. Project or parts truck. '97 Saturn SL DD. 1.9/5-speed. 40+ highway mpg |
|
|
|
|
02-04-2004, 01:09 AM
|
#4 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
A small block truck with engien in the stock location and a short shaft TH350 would take a 4 foot 10 inch drive shaft, asuming you have a coil rear end.
The rear end may not matter...but this is my combo. Measurements are from center of U-joint hole to center of U-joint hole. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
