Windshield washer hose?

[DBear]

Anyone know the correct size of hose for the wiper motor that goes to the 2 sprayers on the cowl??? Believe it or not....there is alot of kits out there but no dimensions. I just want to buy a some by the foot. Thanks

[magwakeenercew2jh]

Originally Posted by DBear

Anyone know the correct size of hose for the wiper motor that goes to the 2 sprayers on the cowl??? Believe it or not....there is alot of kits out there but no dimensions. I just want to buy a some by the foot. Thanks

Looks like the ID is 0.1975. Outside measurement is in the pics.

I see in your avatar you are a RR Republican. Well, since sometimes we
have to "tag" ourselves, this hose measurement was sent to you by a
Social Liberal and Fiscal Conservative.

So, for the good of everyone, I measured it three times.

[In The Ten Ring]

Originally Posted by magwakeenercew2jh

Looks like the ID is 0.1975. Outside measurement is in the pics.

I see in your avatar you are a RR Republican. Well, since sometimes we
have to "tag" ourselves, this hose measurement was sent to you by a
Social Liberal and Fiscal Conservative.

So, for the good of everyone, I measured it three times.

We'll need more information than this. What is your position on ****, *****,*****, ****, and ****.



Just kidding! Political discussion tends to wreck discussion forums.

[magwakeenercew2jh]

Originally Posted by In The Ten Ring

Political discussion tends to wreck discussion forums.

You got THAT right.
For sure!!!!

[DBear]

Originally Posted by magwakeenercew2jh

Looks like the ID is 0.1975. Outside measurement is in the pics.

I see in your avatar you are a RR Republican. Well, since sometimes we
have to "tag" ourselves, this hose measurement was sent to you by a
Social Liberal and Fiscal Conservative.

So, for the good of everyone, I measured it three times.

Hey there....is the hose that goes to the sprayers on the cowll?

Oh....I am glad that you are Conservative in someway at least..lol

[DBear]

sorry...that probably didn't make sense. I meant: Is that the hose that goes from motor to sprayers on cowl section? Also, should the hose fit really tight or just snug? Thanks

[magwakeenercew2jh]

Originally Posted by DBear

Hey there....is the hose that goes to the sprayers on the cowll?

Oh....I am glad that you are Conservative in someway at least..lol

Yup. That's the old stuff I pulled off the nozzles in the cowl. Since I haven't had the cab since it was new,
I can't say 100% this is the exact hose that came on this cab in '68....But I'd bet $1,265 (more or less) that it is.

I bought the same size fresh stuff when I re-fabbed my set-up with an electric (Napa) pump. Plumbed them from
a "Y" at the "OUT" side of the pump to the stock nozzles with this size...Done!

Since I closed off the cowl with some sheet metal, changing the hoses out means I'd have to remove or dislodge the cowl...
very much worth it for me for avoiding leaves, etc....I'm using Vintage Air and if I want uncooled or unheated air, I can open
a wind-wing or window.

So, fresh hose all the way puts off any hose changes at the nozzles for a pretty long while.

[LockDoc]

Originally Posted by In The Ten Ring

Just kidding! Political discussion tends to wreck discussion forums.

Not to mention that it is also against board rules...

LockDoc