|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-18-2015, 01:11 AM
|
#3 |
|
Registered User
Join Date: Sep 2008
Location: San Carlos, Ca.
Posts: 3,048
|
Re: 1986 Front Steering Knuckle Removal
I'm picking up a ball joint remover / installer tomorrow after work. Ill try and get a pic on here if I have time. It goes on with an impact and provides the "pressure" needed. A couple of whacks to the side of where the ball joint stud goes through the casting and they usually pop loose. I have had to pressure both the lower and upper ones to get them free. Might even be able to rent the tool where you are buying your parts.
__________________
Chris '63 k15 long step Vortec 7.4 - L29 Blackbear tune, Five 0 Motorsports injectors, Chris Straub Cam, NV4500, divorced 205  52" front and 63" rear spring swap D44 / 14bff - disc axles Milemarker 9K and 10.5K hydraulic winches 63" & B52 Spring Install http://67-72chevytrucks.com/vboard/s...ng+swap+thread NV4500 Reverse Build Thread http://67-72chevytrucks.com/vboard/s...=reverse+build L29 - 7.4 Vortec Build http://67-72chevytrucks.com/vboard/s...&highlight=L29 |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode