what to replace while doing front lift? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

aggiedave98 · 02-19-2004, 01:28 AM

I'm going to put in a 3" suspension lift into my '89 suburban 1/2 ton 2wd. What should I replace while I'm in there?

inner tie rod?
outer tie rod?
ball joint?

I definitely need to replace the control arm bushings. It seems like there are polyurathene (sp) ones and even ones w/ metal sleeves on them ranging from $30-$80. Which kind are the best? Is there much of a difference?

Seon · 02-19-2004, 11:43 AM

Do it all and have the front wheels aligned. Then you''re Burb will be good for another 20 years

.

aggiedave98 · 02-20-2004, 03:30 AM

Ok, but what about things like the idler arm etc. Should I replace everything??

02-19-2004, 01:28 AM	#1
aggiedave98 Senior Member Join Date: Aug 2003 Location: Sugar Land, TX Posts: 1,007	what to replace while doing front lift? I'm going to put in a 3" suspension lift into my '89 suburban 1/2 ton 2wd. What should I replace while I'm in there? inner tie rod? outer tie rod? ball joint? I definitely need to replace the control arm bushings. It seems like there are polyurathene (sp) ones and even ones w/ metal sleeves on them ranging from $30-$80. Which kind are the best? Is there much of a difference?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-19-2004, 11:43 AM	#2
Seon Registered User Join Date: Nov 2002 Location: Northern CA. Posts: 503	Do it all and have the front wheels aligned. Then you''re Burb will be good for another 20 years .

02-20-2004, 03:30 AM	#3
aggiedave98 Senior Member Join Date: Aug 2003 Location: Sugar Land, TX Posts: 1,007	Ok, but what about things like the idler arm etc. Should I replace everything??



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.