The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 10-22-2015, 09:30 AM   #1
72kool
Registered User
 
72kool's Avatar
 
Join Date: Dec 2012
Location: kearney nebraska
Posts: 613
Blower Motor,interesting problem

This morning i started my truck to warm up before work. i go outside after 15 minutes and it doesnt feel too warm in the cab. Not a big deal because it didnt frost over the windows. I felt the defrost vents and nothing.. i start driving to work and it starts blowing out the vents just fine. ok no problem i think. I get to work and check it when i park, no air through the vents again. Now the heat works well when it works. I have replaced the radiator and heater core and all hoses, all withing past 2 years. heat worked fine this spring without an issuse. it doesnt seem to have any coolant issue, just air flow issue. what would cause this? is it a voltage issue where the blower motor doesnt get enough to engage until im driving?
72kool is offline   Reply With Quote
Old 10-22-2015, 09:46 AM   #2
haysonj
Registered User
 
haysonj's Avatar
 
Join Date: Dec 2007
Location: Santa Maria, Ca.
Posts: 1,423
Re: Blower Motor,interesting problem

Quote:
Originally Posted by 72kool View Post
This morning i started my truck to warm up before work. i go outside after 15 minutes and it doesnt feel too warm in the cab. Not a big deal because it didnt frost over the windows. I felt the defrost vents and nothing.. i start driving to work and it starts blowing out the vents just fine. ok no problem i think. I get to work and check it when i park, no air through the vents again. Now the heat works well when it works. I have replaced the radiator and heater core and all hoses, all withing past 2 years. heat worked fine this spring without an issuse. it doesnt seem to have any coolant issue, just air flow issue. what would cause this? is it a voltage issue where the blower motor doesnt get enough to engage until im driving?
Sounds like loose or dirty connections on the blower motor under the hood or a faulty switch at the dash. also check the ground wire on the blower motor. I believe there is also a high speed resistor over behind the glove box that could also be the problem

.
__________________
69 Chevy 4x4 383 Power
haysonj is offline   Reply With Quote
Old 10-22-2015, 09:53 AM   #3
Chevy 350 Fan
Registered User
 
Join Date: Jan 2015
Location: Channahon IL
Posts: 50
Re: Blower Motor,interesting problem

Does the Amp meter work? if so what does It read? Does it start blowing if its sitting and you rev the engine a little? does it still blow when you come to a stoplight? I remember my old blower motor had a bad bearing and it would sound god awful sometimes and just fine other times. Eventually it got to the point where it would only work about 1/2 the time lol. I changed it out and had no problems. (maybe $15-$20 at auto zone but its made in china!) its kind of a pain in the ass because you have to take off the passenger hood hinge. I tied my hood to a hook in the ceiling with a rope so I wouldn't need to take it all the way off.
Chevy 350 Fan is offline   Reply With Quote
Old 10-22-2015, 06:11 PM   #4
Dave in Ozark
Registered User
 
Join Date: Sep 2015
Location: Rogersville, MO
Posts: 82
Re: Blower Motor,interesting problem

Could you hear the motor running? Perhaps a low vacuum at idle keeping the damper from diverting up to the windshield?
Dave in Ozark is offline   Reply With Quote
Old 10-22-2015, 07:20 PM   #5
Jrainman
Registered User
 
Jrainman's Avatar
 
Join Date: Jul 2015
Location: North East PA
Posts: 684
Re: Blower Motor,interesting problem

Sounds like a ground issue , but could be switch . as stated check connections , then if connections seem good add temporary ground wire to one of the blower motor through bolts rite to your negative terminal on the battery . if that works then just make up a new ground to body if not move on to the switch it self .
Jrainman is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:10 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com