The 1960 - 1966 Chevrolet & GMC Pickups Factory Correct Restoration Thread - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**aotte1** · 12-19-2015, 09:56 PM

What is the Shape of the Leaf Springs Ends

Shape of leaf spring ends, photos below are of 1964 K10 built in St Louis, rear springs. Were the leaf spring ends cut square or were they rounded/tapered some. They could have been both ways depending on supplier and/or where the truck was made.

The last photo shows other rear spring parts.

Note: The bottom helper spring does not look original, in photos 1 and 2 below. Will post photos of front springs next, they are not as rounded, however, not cut square either.

Les

12-19-2015, 09:56 PM	#7
aotte1 Registered User Join Date: Oct 2013 Location: lousiville Ky Posts: 2,645	Re: The 1960 - 1966 Chevrolet & GMC Pickups Factory Correct Restoration Thread What is the Shape of the Leaf Springs Ends Shape of leaf spring ends, photos below are of 1964 K10 built in St Louis, rear springs. Were the leaf spring ends cut square or were they rounded/tapered some. They could have been both ways depending on supplier and/or where the truck was made. The last photo shows other rear spring parts. Note: The bottom helper spring does not look original, in photos 1 and 2 below. Will post photos of front springs next, they are not as rounded, however, not cut square either. Les Attached Images Last edited by aotte1; 12-19-2015 at 10:42 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.