u-bolt torque - The 1947 - Present Chevrolet & GMC Truck Message Board Network

61K10 · 01-05-2016, 01:01 PM

haw much torque on 5/8" u-bolts?

61K10 · 01-05-2016, 05:03 PM

found a table on goggle----------

**kwmech** · 01-06-2016, 12:42 PM

should have been somewhere around 150-180 ft.lbs

61K10 · 01-06-2016, 01:00 PM

thanks kwmech--there was some variables in the table like if plated or not. I am assuming that being cad plating.

01-05-2016, 01:01 PM	#1
61K10 Registered User Join Date: Feb 2012 Location: pleasant valley--placerville ca Posts: 3,039	u-bolt torque haw much torque on 5/8" u-bolts? __________________ 1961 chevy K10 my build is------------61K10 build

01-05-2016, 05:03 PM	#2
61K10 Registered User Join Date: Feb 2012 Location: pleasant valley--placerville ca Posts: 3,039	Re: u-bolt torque found a table on goggle---------- __________________ 1961 chevy K10 my build is------------61K10 build

01-06-2016, 12:42 PM	#3
kwmech Senior Member Join Date: Mar 2003 Location: Colfax-California Posts: 8,713	Re: u-bolt torque should have been somewhere around 150-180 ft.lbs

01-06-2016, 01:00 PM	#4
61K10 Registered User Join Date: Feb 2012 Location: pleasant valley--placerville ca Posts: 3,039	Re: u-bolt torque thanks kwmech--there was some variables in the table like if plated or not. I am assuming that being cad plating. __________________ 1961 chevy K10 my build is------------61K10 build

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.