New project! The "Red Herring"

[JJorgensen52]

Originally Posted by iowaboynca

maybe mock up a template with what you want with angled. Be easier to visualize.

Originally Posted by FarmerSid

Nice latches. I think curved would look better. like iowaboynca said, maybe a template to visualize it better.

Originally Posted by lower50's

I think it's hard to make anything on these trucks square because they are so rounded and angled. I agree with iowaboynca, make template of both see what one looks better. It's all up to what you want.

Thanks fellas! I am hoping to have a few minutes to make up a template this evening.

I didn't think going into this that the squared edge would bother me, but you're right lowers, it really does just look totally out of place!

[JJorgensen52]

Well, since we're having a bit of a cold snap and my garage is uninsulated ... decided to switch it up to working on the fuse block, since I can do that indoors

The first part of this, of course, was triple checking my schematic and finding a half dozen errors I need to correct. The whole thing uses sealed terminals, so there are a few supply wires (you can see fuel pump and e-fan here) which have to have splices in them between the fuse and the relays in the center of the block. It's coming along, though!

Can't upload to my usual photo host tonight for some reason, so attachment it is

[JJorgensen52]

This thing is turning into an octopus! Right about now, I *almost* think I should have bought a Painless harness



On the plus side, I'm at the point now where the engine harness and the chassis harness are tying together, so provided it's not too cold tomorrow I will hopefully have the entire underhood and chassis wired up, leaving just the cab harness to call it finished!