|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-25-2016, 03:53 PM
|
#1 |
|
Registered User
Join Date: Nov 2005
Location: Newton
Posts: 174
|
Front fender lower molding removal
I need to remove the lower rear molding front fender drivers side on my 1972 GMC. Is there a way other than removing the fender I hope.
|
|
|
|
01-25-2016, 04:29 PM
|
#2 |
|
Old member
Join Date: Jan 2002
Location: Liberty, & Garden City S.C. , U.S.
Posts: 19,945
|
Re: Front fender lower molding removal
I maybe wrong and it's been a while but I thought I reached up inside the fender and inner fender well and got mine off.
__________________
1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs. |
|
|
|
|
01-26-2016, 07:47 AM
|
#3 |
|
Registered User
Join Date: Nov 2005
Location: Newton
Posts: 174
|
Re: Front fender lower molding removal
Thanks I will give that a shot.The door lower was a little tough but I was able to get it off fine and back on without removing anything and all the others are not that difficult either.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
