Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
04-07-2016, 08:28 PM | #4 |
meowMEOWmeowMEOW
Join Date: Sep 2009
Location: MKE WI
Posts: 7,128
|
Re: welding advice from pros...?
Honestly, I don't see a ton there thats "wrong". It looks like the lower-side of both welds looks like it didn't get super deep penetration (its the shorter "leg" of the weld and the hard edge). Clearly though, you kept a fairly steady heat and travel speed, because you welds aren't drastically different from each other.
The top side welds look a little colder than the inside joint. Preheat helps with that, but travel and feed speed can help you make up for that a little. Worst case scenario (preheat not helping and amps not helping), you can always have a helper keep a torch on it to keep the preheat up while welding.
__________________
'66 Short Step / SD Tuned / Big Cam LQ4 / Backhalfed /Built 4l80e / #REBUILDEVERYTHING MY BUILD THE H8RDCPTR //\\ MY YOUTUBE CHANNEL REV J HD
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|