|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-25-2016, 07:19 PM
|
#1 |
|
Registered User
Join Date: Sep 2014
Location: Valparaiso, IN
Posts: 300
|
Various metal thickness
What gauge or how thick are the various metal panels of the cab? Is this info listed anywhere?
Specifically the floor, as I have to make one large (8 x8) & several small (1-2" round) patch panels. If I measured correctly, the floor looks to be 18 gauge or 0.05" without paint. I found this web page pretty helpful. https://www.tedpella.com/company_html/gauge.htm |
|
|
|
04-25-2016, 07:26 PM
|
#2 |
|
Registered User
Join Date: Aug 2015
Location: Kelowna, B.C, Canada
Posts: 1,747
|
Re: Various metal thickness
Yes I'm pretty sure that the floor is 18 gauge. That's what I've been using
__________________
Nik...................____ 62 lwb c10 step-side 261 5 spd .........________//__{\_____ ,,,,,,,/__(O)___//___/__(O)_/ my build thread. Sending unit solution |
|
|
|
|
04-25-2016, 08:37 PM
|
#3 |
|
Registered User
Join Date: May 2013
Location: Centerville,Ma.
Posts: 1,223
|
Re: Various metal thickness
I like to use 18 gauge for patch work as it is easier to weld.
|
|
|
|
|
04-25-2016, 09:34 PM
|
#4 |
|
Registered User
Join Date: Aug 2012
Location: Fort Campbell, KY
Posts: 494
|
Re: Various metal thickness
I use 18 for everything since it is a little easier to bend and matches the thickness of the original. I just picked up some 16 gauge I would consider using for the floor if I still had flor work to do. Going to use the 16 to make a new battery tray and patch my inner fenders where they rusted in the front, but that's about it. Good luck
__________________
AIR ASSAULT |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
