|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-14-2016, 03:08 PM
|
#1 |
|
Registered User
Join Date: Jun 2015
Location: Reno
Posts: 34
|
Major Oil pump problem?
I went to change my distributor this morning and upon trying to instal the new part the oil pump did not line up. As usual, I stick a long flathead down inside to line up w/ the new distributor. I could not move it an all either way. It felt very stuck. The weird thing is I had great oil pressure prior to taking anything apart. Was I just not turning it hard enough? Any ideas on this problem would be appreciated.
|
|
|
|
05-14-2016, 07:47 PM
|
#2 |
|
Registered User
Join Date: Dec 2011
Location: winnipeg
Posts: 1,107
|
Re: Major Oil pump problem?
Try bumping the engine over with distributor in and see if the pump shaft turns, disconnect coil wire so it doesn't try to fire.
|
|
|
|
|
05-14-2016, 08:07 PM
|
#3 |
|
Registered User
Join Date: Apr 2013
Location: South Westerlo, New York
Posts: 1,325
|
Re: Major Oil pump problem?
It should turn with no difficulty, is the screw driver perhaps too fat and getting wedged in the intake or block opening?
__________________
Thanks, Joe.. 1969 C/10, 348 C.I., 3X2 bbl. V8, 2004r , LWB. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
