![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Nov 2015
Location: Colfax California
Posts: 1,644
|
Did I just break my vac advance canister?
Just bought an Accel adjustable vacuum advance canister and I was turning clockwise like the directions say, and I must have gone too far because I heard a click and now I can't back it off and it's putting in way to much timing.
Are these things that fragile? I was turning it nice and light Last edited by Mrturner1; 05-20-2016 at 09:45 PM. |
![]() |
![]() |
![]() |
#2 |
Senior Member
![]() Join Date: Dec 2013
Location: Gods country East,Tn
Posts: 8,545
|
Re: Did I just break my vac advance canister?
STEP AWAY FROM THE.TOOLBOX ! Hahaha just ribbing you ! Take it back it's broke .too bad your on the other coast .
__________________
![]() 1967 Factory short bed - Old school '71 - 350 / 4bolt / 487 heads / Edelbrock C3BX Muncie M-22 4 speed / Hurst Comp plus Factory 12 bolt posi 3.73 / 255-70-15 Smoothed firewall / Factory cowl induction Power disc brakes / power steering / 3.5-5" drop |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Nov 2015
Location: Colfax California
Posts: 1,644
|
Re: Did I just break my vac advance canister?
Yeah looks like it's goin back. The good news is I found out that my old vac canister was actually bad. I had a feeling it was and then I tried a couple tests. When I got this one on, the idle would actually change when I un-plugged it from full manifold vac (which my old one used to do) Oh well, try again tomorrow.
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|