TX WTB: Step Bumper license plate lamp pigtail: harness female connector

[jocko]

The title pretty much says it. I have the below - need the female connector this plugs into if anyone has one. Trying to avoid chopping my spaghetti wiring harness any more than it already is, but I need to get this hooked up!
Thanks all.

[DeadheadNM]

Mark I have this style harness for a dual light rear step bumper setup buried somewhere: http://67-72chevytrucks.com/vboard/s...53&postcount=3

Is the dual lamp setup what you need or would any OEM female harness plug for the plate lamp work?

[jocko]

I only need a single lamp setup Pete - do the small (dual) ends of that harness have the female connector that fits to the single pre-split end of your harness? If so, I'd be happy to buy the whole harness or one female connector. I have two of these to do eventually, neither one works at the moment! I can't tell from the pic if it has the female connector I need - the male end looks like mine though.

[DeadheadNM]

Female end should be same. I'll dig around later today for it - may also have a parts harness w the female end.

[jocko]

thanks Pete!

[jocko]

Call off the dogs! Specialtyretail had the whole taillight harness available - just bought it. Thanks for the help. Gonna PM you Pete in case you're out in the garage ripping it apart to find the pigtail!

[DeadheadNM]

Check! All good thanks.