![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jan 2016
Location: fountain valley california
Posts: 135
|
bed floor rail support repair
This isnt my truck bed but the part i circled on my truck is all cut up and rusted. has anyone taken this off and made there own bracket. im not sure what the correct term for this part is, it looks like i could cut it out and replace with angle iron of some kind.
|
![]() |
![]() |
![]() |
#2 |
Moderator
![]() ![]() Join Date: Aug 2011
Location: China Spring, TX
Posts: 7,280
|
Re: bed floor rail support repair
Mark K has a write up on how to install them, I would suggest removing them the same way. Under this link look for "Angle Strip Removal and Installation for 54-72 GM Bed Sides"
http://www.mar-k.com/index.php?p=tips-and-tricks
__________________
Master Chief, US Navy, Retired 1964 C10 Step-side Short Bed - In Progress 2009 2500HD Duramax LTZ 1948 GMC Panel 1956 Big Window Stepside 1953 5 Window Chevy Stepside 1932 Coupe New Seat Foam for Bench Seats? |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Mar 2010
Location: thomastown mississippi
Posts: 1,261
|
Re: bed floor rail support repair
Not to hijack ebaby35's thread but think about this. It looks to me that the outside bed boards support the bedsides by the angles sitting on the boards. As time goes by & the wood deteriorates the bedsides loose support & may start to sag. What if the angles were low enough on the bedsides to sit on the cross sills & the boards sat on top on the angles. Then you would have metal supporting metal & metal supporting wood. Just thinking out loud, & me thinking alone is dangerous enough!
![]() |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|