|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-16-2017, 05:23 AM
|
#1 |
|
Registered User
Join Date: Nov 2005
Location: McKinney, Texas
Posts: 465
|
Control arm bushing question
In the process of replacing my upper and lower control arm bushings, 73/87 style, and have a question I need help with. After installing the bushing on one side of the arm, I slid the shaft into the bushing and it seems sloppy. Like at least 10-20 mils or more. Is the fit of the shaft to the inner sleeve supposed to be a press fit or tight fit or should it move around easily? Thanks!
Last edited by bighead; 05-16-2017 at 06:13 AM. |
|
|
|
05-16-2017, 07:04 AM
|
#2 |
|
Senior Member
 
Join Date: Jan 2011
Location: Hayes Va
Posts: 4,569
|
Re: Control arm bushing question
It will move some and will tighten up when you get it all pressed in and the ends pulled up tight.
Jimmy
__________________
60 to 66 Chevy and GMC window decals http://67-72chevytrucks.com/vboard/s...d.php?t=661131 Good friends, good food and a hotrod what else do you need? 1966 BBW long fleet Daily driver 1965 BBW short fleet Sold and going to a good home 1965 Suburban 2003 3500 Duramax 2005 Ultra Classic |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
