The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 06-01-2017, 03:50 PM   #1
LS short box
Registered User
 
Join Date: Jun 2015
Location: Carlos MN
Posts: 1,979
Re: Wiring starter with my swap

I typically run a large gauge wire from the starter stud to the alternator. I think I used 6 gauge last time. From the starter along the left of the engine where the oil pan and block meet. Then around the front using the oil pan bolts and metal cushion with rubber clamps to hold the cable in place. Then on to the alternator.
LS short box is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:18 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com