|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-01-2017, 05:56 PM
|
#1 |
|
Registered User
Join Date: Mar 2003
Location: Northern Illinois
Posts: 2,181
|
60-63 vent window question
Okay, so I installed the new vent window rubber, and I'm re-installing the vent window in the door.
On all 8 example doors I have here, the vent window rubber sits tucked into the door channel, leaving a small gap between the rubber and the door, so that's how I've installed my window. I'm wondering, though, if the rubber flap is supposed to go OUTSIDE, sealing the gap that would otherwise exist. The factory manual provides no guidance here. Can anyone confirm how this is supposed to be installed? Thanks, B |
|
|
|
07-01-2017, 11:49 PM
|
#2 |
|
It's Better With Nitro
Join Date: Apr 2008
Location: Chino Hills, CA
Posts: 2,262
|
Re: 60-63 vent window question
All of the rubber gasket sits inside the channel.
__________________
1963 C-10: Deluxe-optioned cab, shortbed, fleetside Pontiac 462 ci, Kauffman D-Port alum. heads 4L80E, narrowed sheetmetal Ford 9-inch Tubular front and rear suspension Custom 6-piston front disc and 4-piston rear disc brakes |
|
|
|
|
07-03-2017, 04:29 PM
|
#3 |
|
Registered User
Join Date: Jan 2009
Location: Burbank, CA
Posts: 3,619
|
Re: 60-63 vent window question
I think this has been talked about on another thread. If my memory serves me correctly there was one person that was able to get the rubber to go on the outside but he said it was vary difficult and had to be vary careful not to scratch the paint. I think some have stuck a scrap peace of rubber in between to close the gap.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
